Tag: Bolt Action

224 Valkyrie Remington 700 Build P8: Barrel Break In, First Groups, First Loads

Breaking in the barrel for a rifle you’ve built is a truly unique and exciting experience. Will the gun blow up? Will the rifle shoot well? Will my new trigger meet my expectations? It’s like sea trials for a new ship, but with a precision instrument. As I was finishing my Remington 700 224 Valkyrie […]

224 Valkyrie Remington 700 Build P7: AICS Magazine Conversion

When you go “off the script” (like building a 224 Valkyrie bolt-action rifle) you can expect some challenges. One such challenge with this kind of build is getting a reliable magazine configuration setup. A lot of guys have spent a lot of hours tinkering with magazines, springs, followers, lip geometry and more with a common […]

224 Valkyrie Remington 700 Build P6: KRG Bravo Stock, TriggerTech Special Trigger

All of the hard work I’ve put into this 224 Valkyrie Remington 700 build is about to come together, literally! With a complete barreled action assembly, it’s time to install our trigger, and then mate the stock and barreled action together. I can hardly wait to take this rifle to the range! And by the […]

224 Valkyrie Remington 700 Build P5: Custom Thread Protector

A threaded muzzle is great, but if you aren’t using a muzzle brake or suppressor, you’ll need something to protect the (fragile) threads! That’s where a thread protector comes in handy. One of the best ways to make a thread protector is with a cut-down section of barrel blank. Good thing I had this “extra” […]

224 Valkyrie Remington 700 Build P4: Muzzle Threading and Barrel Install

Here’s my philosophy: why not have a threaded muzzle? If you want to use a muzzle brake or a suppressor, you’re all set! If you don’t use a muzzle device, you put a thread protector on, and you’re good to go. So now that we’ve completed the breech-end barrel work, let’s move on to the […]

224 Valkyrie Remington 700 Build P3: Chambering and Machining

Sometimes you have to do a lot of “prep work” to get to the “fun work”. Well, after building out our build-sheet, and preparing and aligning the barrel, we’re now to the fun part of this build! That’s right, it’s time to start machining the tenon, and cutting the chamber! Disclaimer Ultimate Reloader LLC / […]

224 Valkyrie Remington 700 Build P2: Barrel Prep and Alignment In the Lathe

How you secure your barrel in your lathe, and the attention to detail aligning the barrel’s bore to the lathe spindle axis will both have a big effect on the outcome of your barreling work. In this post, we’ll continue our 224 Valkyrie Remington 700 bolt-action rifle build with a focus on a few things: […]

224 Valkyrie Remington 700 Build P1: Planning the Build

I’ve always wanted to build a Remington 700 custom bolt-action rifle, and now is the time! As a part of the lager 224 Valkyrie project (two rifle builds, reloading, ballistics, …) this smaller collection of videos and articles will outline a complete Remington 700 build- from start to finish! Later, we’ll compare ballistics and accuracy […]

Reloading Safety

Polls