Category: Kyle Shields

Page 1 of 2
1 2

Does Rimfire Thickness Matter?

One source of variation in rimfire ammunition is rim thickness. In this video, we’ll show how to measure it using a Hornady Lock-N-Load 17-22 Rim Thickness Gauge.  Disclaimer Ultimate Reloader LLC / Making with Metal Disclaimer: (by reading this article and/or watching video content you accept these terms). The content on this website (including videos, […]

Reload Faster: NEW RCBS MatchMaster Powder Funnel Kit

Have you ever been curious if there was a faster way? In this video we test the new RCBS MatchMaster Funnel Kit and compare it to a few other funnels!  Disclaimer Ultimate Reloader LLC / Making with Metal Disclaimer: (by reading this article and/or watching video content you accept these terms). The content on this […]

9mm Case Processing Hack: NEW Hybrid Die from FW Arms

FW Arms’ .223 dies were central to the success of our mega brass processing project with Mojo Precision and Mark 7. This time, we’re testing FW Arms’ 9mm hybrid sizing die with dynamic spring hold down!  Disclaimer Ultimate Reloader LLC / Making with Metal Disclaimer: (by reading this article and/or watching video content you accept […]

TESTED: RCBS Universal Hand Priming Tool

Tired of having the incorrect shellholder for your hand primer? Ever have a shellholder go missing at the most inopportune time? The RCBS Universal Hand Priming tool eliminates the need for shellholders!  Disclaimer Ultimate Reloader LLC / Making with Metal Disclaimer: (by reading this article and/or watching video content you accept these terms). The content […]

Improve Your Die Setup: Lock Rings & Loading Full Progressive .308 on the X-10

We’ve been shooting a lot of .308 lately —in fact —we are out! We need to crank out a ton more, so this was a great time to set up a progressive press. I’ve been working with the Frankford Arsenal X-10 lately. Along the way, I’ve come across some notable gear like the Frankford Arsenal […]

Automated Bulk .223 Loading on the Mark 7 Apex 10

Bulk processing over 40,000 .223 cases from Mojo Precision on the Mark 7 Apex 10 was just the start of the process. We decapped using FW Arms dies and Berdan Sentry, resized with the Lyman carbide pro die, and trimmed with the Mark 7 Power Trim Xpress. We decided to run a dedicated priming session […]

.223 Bulk Processing: 40,000 Cases!

We’ve finally finished processing a 55-gallon drum of .223 brass from Mojo Precision with help from FW Arms and Mark 7. Watch and read on to see what it took!  Disclaimer Ultimate Reloader LLC / Making with Metal Disclaimer: (by reading this article and/or watching video content you accept these terms). The content on this […]

How Good Are They? Berry’s 124 Gr. HBRN-TP 9mm Bullet

I’ve long trusted Berry’s plated bullets for economical practice loads — but how accurate are they? Today we find out if you have to forgo accuracy for lower cost!  Disclaimer Ultimate Reloader LLC / Making with Metal Disclaimer: (by reading this article and/or watching video content you accept these terms). The content on this website […]

Prime with a Die? RCBS Ram Priming!

We’ve looked at a number of priming methods including bench-mounted, progressive, and hand priming systems. Did you know you can prime on any press with the RCBS Ram Prime?  Disclaimer Ultimate Reloader LLC / Making with Metal Disclaimer: (by reading this article and/or watching video content you accept these terms). The content on this website […]

Page 1 of 2
1 2