Tag: .223 Remington

Page 12 of 16
1 10 11 12 13 14 16

AR-MPR: Accurizing the Upper Receiver – Part I: Prep and Welding

In my last post, outlined some ideas and goals for talking the slop out of the fit between the upper and lower receivers on the AR-MPR rifle. The first step is to remove the gaps between the sides of the upper receiver lugs, and the channels at the front and back of the lower receiver. […]

AR-MPR: Accurizing the Upper Receiver – Overview

A while back, I posted some AR-MPR rifle accurizing plans. This was my first-pass at enhancing the accuracy of the AR-MPR rifle. Since this post, I have had a few range visits (sorry, don’t have photos as the range does not permit photography) where I did not see the kind of accuracy and consistency that […]

RCBS Rifle Bullet Feeder on RCBS Pro-2000 – Some Notes

For a while I have been wondering about the RCBS Rifle Bullet Feeder – and now that I’ve setup and used the 22 caliber kit on the RCBS Pro-2000, I know a lot more about how this tool works, and what it is capable of. Setting up the unit is fairly straightforward, with a requirement […]

AR-MPR – Hornady Lock-N-Load AP Loading 223

Continuing with our coverage of high-volume loading of .223 Remington and 5.56 NATO ammunition for the AR-MPR project, this time we’ll look at using the Hornady Lock-N-Load AP to load for the AR-15. In this video, I’ll show loading in full progressive mode with the use of the Hornady Lock-N-Load Case Feeder system as well. […]

AR-MPR – RCBS Rifle Bullet Feeder on Pro-2000 Loading 223

If you have an AR-15, you know that they tend to chew through ammo very quickly. It’s a lot of fun, but it also gets expensive really quickly, especially if you are requiring match-grade ammunition. The solution is to load .223/5.56 on a progressive reloading press. If you really want to crank it up, you […]

AR-MPR- RCBS Rifle Bullet Feeder Overview Part II

Recently, I gave a quick overview of the RCBS Rifle Bullet Feed System. In that post, I gave an overview of what’s included in the kit. In this post, we’ll take a look at what this system looks like installed on a 5-Station reloading press (The RCBS Pro-2000 in this case). As you can see […]

AR-MPR- RCBS Rifle Bullet Feeder Overview

Phase III of the AR-MPR AR-15 rifle project is really all about “precision mass production” of the ammunition that we’re developing in Phase II (precision single stage loading). There are a couple key things that we’ll explore: first, we’ll look at progressive reloading of .223 / 5.56 ammunition. We’ll also extend our production rates by […]

AR-MPR Phase II – Checking and Correcting Bullet Concentricity

If you are a precision shooter, you care about consistency for the cartridges that you shoot. One of the most important factors to measure and control when reloading match ammunition is bullet concentricity. Simply stated, this is the alignment of the case and bullet. If you have “good concentricity”, you will have the axis of […]

Page 12 of 16
1 10 11 12 13 14 16



Reloading Safety

Polls