In this post, I’ll finish covering the accurizing steps and experiments for the AR-MPR upper receiver- so far, we’ve covered the following: AR-MPR: Accurizing the Upper Receiver – Overview AR-MPR: Accurizing the Upper Receiver – Part I: Prep and Welding Following the welding process, I carefully milled and measured the sides of the upper receiver […]
In my last post, outlined some ideas and goals for talking the slop out of the fit between the upper and lower receivers on the AR-MPR rifle. The first step is to remove the gaps between the sides of the upper receiver lugs, and the channels at the front and back of the lower receiver. […]
A while back, I posted some AR-MPR rifle accurizing plans. This was my first-pass at enhancing the accuracy of the AR-MPR rifle. Since this post, I have had a few range visits (sorry, don’t have photos as the range does not permit photography) where I did not see the kind of accuracy and consistency that […]
The AR-MPR Upper Assembly shown here during test fitting of components – Click here for larger view – Images Copyright 2010 Ultimate Reloader Before we actually start with the build process for the AR-MPR rifle, I want to post some information about the parts and tools that are required for such a build. In this […]
